Intermatic 158ei12087 User Manual

• 1-2-4-8 Hour time ranges.

• Continuous HOLD “ON” feature.

• Available in White, Ivory, & Light Almond

15A / 120V / 1800W Resistive

8.3A / 120V /1000W Tungsten

1/4 HP Motor

Leads: Black-Line, White-Neutral, Red-Load, Green-Ground

1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH, TURN OFF POWER AT CIRCUIT

BREAKER AND TEST THAT POWER IS OFF BEFORE WIRING.

2. Remove wall plate and disconnect light switch.  Make sure both “hot” and neutral wires are

present in the junction box. (See Fig. 1.) If both wires are not present, additional wiring will be

necessary before installation can be completed.

3. Connect red timer wire to wire from fixture using wire connector. Connect black timer wire to the “hot” (usually black or red)

wire in junction box using wire connector. Cut white wire in junction box (or open splice) and strip 1/2” of insulation on both wires.

Connect white timer wire to white wires in junction

box using wire connector. (See Fig. 2)

4. If the wall switch you are replacing had separate

grounding conductors connected to the GREEN

screw on the switch, make sure to connect these to

the green wire from the timer with a wire connector.

5. Check that all wire connections are secure.

6. Place all wires inside junction box.  Fit timer into

junction box.  Next, install timer using (2) mounting

screws furnished.

7. Reconnect your electrical power.

To enter timer mode, press and release the push

button (for less than 2 seconds) repeatedly to select one of the four time settings or OFF ( 1 hour - 2 hours - 4 hours - 8 hours -

OFF).  The illuminated LED 

indicates which time setting is selected and the connected load is turned ON.  Timer starts counting down until time out is

reached, all 5 LED’s go off and the connected load turns OFF.

To turn timer ON for extended periods of time, press and hold the push button for more than 2 seconds.  Timer enters HOLD

mode, HOLD LED turns on, and the connected load is turned ON.  To exit HOLD mode press and release the push button, all 5

LED’s go off and the connected load turns OFF.

If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair

or replace it, at its sole option, free of charge. This warranty is extended to the original household purchaser only and is not transferable. This

warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units

which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d)

damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED’s and batteries; (f) the finish on any portion of the product,

such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or

reinstallation costs.

This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product,

along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After

Sales Service/7777 Winn Rd., Spring Grove, Illinois 60081-9698/815-675-7000  http://www.intermatic.com   Please be sure to wrap the product

securely to avoid shipping damage.