Bunn CDS-3 User Manual

SERVICE (cont.)

WHIPPER MOTOR

FIG. 8 WHIPPER MOTOR

P1924

Location:

The whipper motor is located on the back side of

the whipper motor mounting panel.

Test Procedure:

1. Disconnect the dispenser from the power source.

2. Disconnect the white/red and white/brown wires

of the main wiring harness from the black leads of

the whipper motor.

3. With the CDS hopper level lower than the probe,

press and hold the SERVICE switch and check the

voltage across the disconnected harness wires with

a voltmeter. Connect the dispenser to the power

source. The indication must be:

a) 120 volts ac for 120 volt models.

b) 230 volts ac for 230 volt CE models.

4. Disconnect the dispenser from the power source.

If voltage is present as described, replace the motor.

If voltage is not present as described, refer to the wiring

diagrams and check the dispenser wiring harness.

Removal and Replacement:

1. Disconnect the dispenser from the power source.

2. Open the dispenser door and remove the hopper

assembly out the front of the dispenser.

3. Remove the four #8-32 screws securing the hopper

support panel to the auger motor mounting panel

and the whipper motor mounting panel.

4. Slowly lift the hopper support panel up and discon-

nect the red/black and green wires from the hopper

switch.

5. Pull the mixing chamber out of the whipper cham-

ber.

6. Twist the whipper chamber clockwise and pull it off

the whipper chamber receptacle.

7. Pull the frother off the motor shaft. Notice the flat

side on the shaft and the matching flat inside the

frother. It is important that these two flats are lined

up when reassembling.

8. Slide the receptacle with seal off of the motor

shaft.

NOTE: To remove the receptacle only, rotate clockwise

until the receptacle clears the nuts and slide off of the

motor shaft.

9. Slide the slinger off of the motor shaft.

10. Remove the two nuts securing the whipper chamber

receptacle and whipper motor to the front panel.

11. Disconnect the black leads on the motor from the

white/red and white/brown wires of the main wiring

harness and remove the motor.

12. Install new motor on rear of front panel and secure

with two nuts. Connect the black leads from the

motor to the main wiring harness. Refer to Fig. 9

29793 011500