Blaupunkt rp4-ch11 User Manual

Pacific Accessory Corporation

| Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com

www.pac-audio.com

Pacific Accessory Corporation

RP4-CH11

Radio Replacement & Steering Wheel Control Interface

for Chrysler/Dodge/Jeep Vehicles

Rev. 112811

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The RP4-CH11 interface allows the replacement of a factory radio in select Chrysler/Dodge/Jeep vehicles with MSCAN or

LSFT-CAN databus radios. Using this interface will retain factory features such as steering wheel controls (SWC) vehicle

entertainment system (VES) and the factory audio amplifier whenever the original radio is removed. The RP4-CH11 also

provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination,

reverse trigger and parking brake.

1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the

interface into the vehicle (see next page for setting chart).

2. When the interface is first plugged into the vehicle the LED will flash indicating the auto detect sequence. Once the CAN-BUS

speed is detected the LED will illuminate and should be on at all times when the interface is on. The LED will also flash whenever

a SWC button is pressed

3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless

you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing

and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to flash 4 times.

Red / White

P.B. Output (-)

Purple / White

VSS Output

Blue / White

Amp Turn On Input

Red

Acc. Output (1 amp)

Orange / White

Illum. Output (+)

Green

Reverse Output (+)

Interface Connector

Yellow

Battery +12v

Black

Ground

Blue

Antenna On Input

White

Front L + input

White / Black

Front L - input

Grey

Front R + input

Grey / Black

Front R - input

Green

Rear L + input

Green / Black

Rear L - input

Purple

Rear R + input

Purple / Black

Rear R - input

Vehicle Connector

SWC Connector

Blu/Yel

Kenwwod, Newer

JVC, OEM or

Blaupunkt

3.5mm Jack

Alpine, JVC,

Clarion, Pioneer,

Sony, Valor, Boyo,

Dual, Visteon or

Advent

Accessory Output

+12volts 1amp max.

Pacific Accessory Corporation

Interface Connector

See above chart for

wire color descriptions.

Vehicle Connector

See above chart for

wire color description.

SWC Connection

See above chart for
different radio type
connections

Wiring

SWC Connection

Page 1