Dacor DYF48BNDI User Manual

Installation Instructions

IMPORTANT:

 

ƒ

Install the custom handles prior to installing the panels on the 

refrigerator. 

 

ƒ

Create custom door overlay panels according to the 

specifications in the Custom Panels and Handles section.

 

ƒ

Dacor is not responsible for customer installed molding or 

decorative panels that need to be removed or replaced to 

service the refrigerator.

Handle Installation

Before installing a custom panel assembly, install the custom 

handle hardware.
Counter-sink the screw head into the back of the panel to allow 

the panel to slide into place smoothly and for proper fit.

Top Grille Panel Installation

1.  Grasp both ends of the top grille. Push straight up, then pull 

straight out. Place the top grille panel-side down on a soft 

working surface.

2.  Remove one end cap by loosening the nuts and sliding off the 

end cap.

Custom Panel and Handle Installation

3.  Slide the panel into the top grille 

channel and reattach the end 

cap.

4.  Replace the top grille in the 

cabinet side trims and pull the 

panel down slightly to lock it into 

place.

Door Panel Installation

1.  Remove all tape and door bracing from the refrigerator and 

freezer doors.

2.  Open the refrigerator and freezer compartment doors.
3.  Remove the handle side and top trims.

4.  Slide the custom panels into the bottom and hinge side trims 

on the refrigerator compartment and freezer compartment 

doors, making sure that the backer panel fits into the hinge 

side trims.

5.  Reinstall the handle-side and 

top trims.

6.  Remove the film from the screw 

covers C. Slide or snap the 

screw covers into the handle 

trim section.

7.  Check refrigerator level and 

alignment. Adjust if needed.

Front View 

Front View

Side View