Crestron st-btp User Manual

Crestron ST-BTP 

Rechargeable Power Pack

3.  Slowly rotate ST-BTP into compartment so that external face is 

visable.  

4.  Verify proper installation with audible click of rechargeable 

power pack into battery compartment. Touchpanel latch secures 
the ST-BTP and prevents the power pack from falling out.  

INSERT THIS END

OF ST-BTP INTO

TOUCHPANEL FIRST

TOUCHPANEL

LATCH FITS

INTO THIS

CUT OUT

 

Complete the following steps to remove the ST-BTP from a SmarTouch 
STS touchpanel. 

1.  Place touchpanel screen-side down on a clean and soft surface. 
2.  Lift latch up, one edge of ST-BTP pops out of touchpanel 

battery compartment.  

3. Rotate ST-BTP and remove.  

Due to the memory effect of NiCad cells, Crestron recommends that the 
ST-BTP be fully discharged for every 25 charge/discharge cycles. The 
ST-BTP can be fully discharged while in the touchpanel. A button to 
fully discharge the touchpanel should be available within a designated 
screen design. This button has a special software identity (reserve join 
number, 1036) and can be recreated and programmed onto any page in 
the project. Consult your area dealer if this feature cannot be located.  

•  5