Brother HL-2400CEN User Manual

CHAPTER 4 CONTROL PANEL

4–19

 
 The automatic interface selection has been factory set. If you want to
select a specific interface manually, use interface mode to select it.
 

 Display  Message

 Interface  Mode

 

I/F=PARALLEL

 Parallel  interface

 

I/F=RS-232C

 Serial  interface

 

I/F=EXTEND I/O

 Extended I/O interface

 

I/F=AUTO

 Auto interface selection

 

 Select the setting menu and enter the sub-setting menu to change the
setting as follows:
 
 ■ Automatic Interface Selection
 
 When you select this function with the 

 button, the display shows the

next sub-setting menu.
 You must set the time out for the auto interface selection from 1 to 99
seconds with the ▲ or ▼ button:  factory setting = 5 seconds. This time
out is the duration during which the printer will not allow another
automatic change to the interface.
 Even if you choose the automatic interface selection, you must set the
communications parameters for the serial interface, high speed / bi-
directional communications for the parallel interface and the optional
interface settings if the installed MIO card requires them. See the tables
below.
 
 For more information about automatic interface selection, see