Belson gh2270 User Manual

8. Bring hood forward and release the tilt-control lever.

9. The hood locks and falls into place.

10. To adjust hood height, place one hand on the dryer base, 

hold the column with the other hand and pull up.

11. The hood has two tilt positions. To adjust, press tilt-control lever and push 

hood upward. Press tilt-control lever again and pull down the hood.

12. Unit is ready to use. Plug in and turn on.

Warning: Be very careful when using unit for a long period of time as hood and
adjustable column might get hot. 

13. Use high heat to dry wet hair and switch to lower heat setting as hair dries. 
14. For wigs and hairpieces, use the Cool setting to dry synthetic hair and the 

Low setting for natural hair.

Caution: High heat can damage wigs or hairpieces.

1. Grip hood handle, tilt back slightly and press tilt-control 

lever.

2. Move hood back to the center and down.

This product is for household use only.
Important: For warranty verification, please do not remove line cord sticker.
When you first plug in the unit, you might notice smoke while unit is heating.
This is normal and does not represent any danger to user or defect in the unit. Let
unit operate until the smoke dissipates. It should take about 30 seconds.
TO SET UP YOUR DRYER
1. Place dryer on a hard, level surface and at a comfortable height for opening.

2. Press the two bottom side locks firmly, at the same time, 

until the hood is completely released.

3. Grip handle and lift up the hood.

4. Make sure the bottom part of the column fits into the slot.

5. Tilt hood back and press tilt-control lever.

6. Find the two slots on the side of the column.

7. While still pressing tilt-control lever, move back side 

of the hood forward over the two slots.

GH2270Pub600069  5/2/05  10:18 AM  Page 4