Nero nero cover designer Quick Setup Guide

Page of 62
Quickstart Cover Designer 
Settings  
  11 
 
You must pre-define any user-designed paper stocks before you can use them. 
4.2.2 Printer Calibration 
Because printers are mechanical devices that are subject to minimal variations 
while printing, we recommend the you calibrate the printer once after you have 
chosen the label type and selected the printer.  
1.  Prior to calibration, select the desired label type and the printer. 
2. Select the 'Preferences' command on the 'File' menu and click on the 
'Printing' tab.  
3.  Click on the 'Print Calibration Sheet' button.  
 
4.  Take the paper out of the printer. Fold the paper horizontally and vertically in  
the middle. 
The dotted line indicates the current calibration setting. 
5. Unfold the paper again and compare where the horizontal and vertical fold 
lines meet the intersection of the axes.  
The intersection point indicates printer deviation in millimeters relative to the 
center of the page. 
6. If there is a difference between the fold lines and the current setting, enter 
the actual horizontal and vertical values on the 'Printing' tab and then print 
another calibration sheet.  
7. Fold that paper again horizontally and vertically in the middle. The fold lines 
should now coincide with the dotted lines. If this is the case, you have 
successfully competed printer calibration. (If not, repeat the appropriate steps 
to perform the calibration.) 
8.  Click on the 'OK' button to close the tab and end calibration.