Behringer Racktuner BTR2000 User Manual

RACKTUNER BTR2000

DEUTSCH

4.1.2 Tuning with the built-in microphone

To be able to work with the built-in microphone, there must be no cable plugged into the

INPUT2 connector in the back of the BTR2000 and the MUTE button must be depressed.

Select INPUT 2 with the INPUT switch on the front of the BTR2000. The 2/MIC LED lights up.

Mute this channel by pressing MUTE/LIGHT; the MUTE LED above the MUTE/LIGHT button

lights up. The built-in microphone is now activated and ready for use.

Position your instrument as close as possible to the BTR2000. Make certain that there is as little

noise as possible to disrupt the tuning process.

Tune your instrument as described in steps 3 through 9 in chapter 4.1.1.

4.1.3 Tuning with a reference tone

The BTR2000 can generate and output notes. You can then tune your instrument by ear without an

optical display.

If your instrument is plugged into INPUT 1, the reference tone is output only through the

SOUND output connector; if it is plugged into the INPUT 2 connector and there is nothing

plugged into the SOUND output, the reference pitch is played through the MAIN output

together with the instrument signal.

Select the tuner mode you wish to use (see chapter 4.2).

The BTR2000 can only recognize certain pitches depending on the tuner mode selected.

Calibrate the reference tone and set the transposition if desired (see chapter 4.3 / 4.4).

Briefly press the SOUND/METRONOME button. The sound mode is activated and the SOUND

LED above the SOUND/METRONOME flashes.

The display shows the volume level currently set (1, 2, ... 12).

The unit emits the lowest pitch available in this mode or the last pitch set in the tuner (even if it

is not available in the currently selected tuner mode) through the SOUND and/or MAIN connector

on the back panel of the BTR2000.

The volume of the reference tone can be set with the wheel.

After briefly pressing the TRANSPOSE/REF button you can turn the wheel to change the

reference tone emitted depending on the selected tuner mode. During this adjustment the

TRANSP and SOUND LEDs are illuminated.

After a short time or after the TRANSPOSE/REF button is pressed again, the unit returns to sound

mode and the wheel can again be used to control the volume.

Tune each string of your instrument to an appropriate reference tone.

When you press the MUTE button, the MAIN output (instrument sound and possibly the reference tone

as well) is muted; the SOUND output is not affected.
To exit sound mode, briefly press the SOUND/METRONOME button again. The SOUND LED will go

out and the tone will no longer be emitted.

4.2 Selecting tuner mode

The open strings on each instrument (e.g. guitar, bass, ukulele) are tuned differently. It is also possible

to deliberately tune an instrument such as a guitar to a so-called open tuning to make it easier to play

in a particular key. The BTR2000 provides a tuner mode to suit many different purposes so you can

optimally  tune  your  instrument.
Depending  on  which  of  the  11  tuner  modes  you  select,  the  tuner  only  recognizes  specific  pitches:
Chromatic  (chr)

The tuner can recognize all 12 half-tones of a scale. (C - C sharp - D - D sharp - E - F - F sharp - G - G

sharp - A - B flat - B)
Guitar (GUI)

The tuner recognizes the pitches of a 7-string guitar. (B - E - A - D - G - B - E)

4. TUNER