Furuno gp-330b User Manual
6
2. WIRING, SETTINGS
2.1 NMEA 2000
®
Connection
The LEN (Load Equivalency Number) for this equipment is 3.
2.1.1 Direct Connection
Insert the contact pin (supplied) into the #5 socket of the GPS Receiver connector
to activate the termination resistor. (See page 8 for location of #5 socket.) Route
the cable assembly to the NMEA 2000® device. Coil any excess cable and secure
it with a cable tie to prevent damage. Connect the cable assembly to the NMEA
2000® device.
to activate the termination resistor. (See page 8 for location of #5 socket.) Route
the cable assembly to the NMEA 2000® device. Coil any excess cable and secure
it with a cable tie to prevent damage. Connect the cable assembly to the NMEA
2000® device.
- NavNet 3D Series MFD
- Radar Sensor*
- FI-50 Series Instrument
- Radar Sensor*
- FI-50 Series Instrument
* Cut plug from cable and connect
wires to terminal/connector.
wires to terminal/connector.
Cable Assembly
22-1025-02 (6 m)
22-1025-06 (10 m, option)
22-1025-02 (6 m)
22-1025-06 (10 m, option)
GP-330B
Termination
Resistor: ON
Termination
Resistor: ON