Behringer lx1-x User Manual

X V-AMP LX1-X User Manual

In contrast to the pitch shifter, the detune effect (4) creates a modest out-of-

tune interval, consisting of only a fraction of a half-tone. It sounds roughly like a 

permanently activated chorus.  
The second parameter controls how much your tone detunes:

for models 1 to 3 (-12/-7/-5/-3/+3/+4/+5/+7/+12 half-tones),

for model 4 (-20 to +20% of a half-tone).

The third parameter lets you select between different effects modules: 

pitch shift (1), T-Arm (2), Whammy (3) and detune (4).

TREMOLO: Simulates the classic Fender DeLuxe tremolo as well as the Vox AC15 

and Gate tremolo. Ever since Trip Hop gained on importance, this volume 

modulation effect is totally in.
The second parameter controls the dependence of modulation tempo on volume: 

loud input signal = quicker modulation, lower input signal  = slower modulation.
The third parameter lets you alternate between different tremolo types: 

Fender (1), Vox (2), Gate (3) and Panning (4).
ROTARY: This is the quintessential simulation of the classic organ effect normally 

produced by speakers rotating at slow or fast speed in an extremely heavy 

speaker cabinet. This effect uses the physical principle of the Doppler effect to 

modulate the sound.
The second and the third parameters control modulation sound.
FLANGER: This effect is self-explanatory. Originally the flanger effect was 

produced by running two synchronized tape recorders at the same time. 

The same signals (e.g. a guitar solo) were recorded on both machines. Putting a 

finger on the left reel of one of the machines caused it and the speed of the 

playback to slow. The resulting delay produced phase shifts of the signals. 

Outstanding examples of this effect genre are for example the Ultra Flanger on 

the BF-3 from Boss (1), and the classic BF-2 (2) as well as the Flanger from MXR (3) 

and A/DA (4).
The second parameter controls the resonance (effect feed-back to the input), 

and the third parameter selects the flanger model (1 - 4).
CHORUS: This effect adds a slightly modulated off-key element to the original 

signal, thus creating a pleasant floating effect through variations in pitch. One of 

the most often used studio chorus effects was the Tri Stereo Chorus, with its 

12 (!) voices that are modulated against each other. The X V-AMP offers you this 

effect in two versions (1, 2). Two additional classics are the Boss Chorus Ensemble 

CE-1 (3) and the Roland Dimension D (4).
The second parameter controls modulation depth, and the third parameter 

selects the chorus model (1 - 4). Modulation speed can be determined using 

the TAP key. High depth and speed values create a signal that is noticeably 

out of tune.
AUTO WAH: The American funk in the ’70s proved that auto wah had many 

possible applications. Instead of regulating the filter frequency with your foot, 

our effect does this automatically, depending on the signal level. In doing so, 

our effect is similar to the EHX MuTron III in the up position.
The second parameter determines how quickly the filter is shifted; the third 

parameter selects the effects block (1 - 4).
P-FUNK’N: This is our attempt at replicating the legendary MuTron III, and we 

succeeded! The most famous user of this effect is probably Bootsy Collins. 

The MuTron III had an up/down switch. Here, the effect resembles the MuTron in 

the down position.

The second parameter determines how quickly the filter is shifted, while the third 

parameter determines the effects block (1 - 4).

6.1.3  Special effects
WAH WAH: The legendary Wah Wah effect owes its fame mainly to Jimi Hendrix. 

Describing it is certainly more difficult than simply listening to Hendrix using it 

on Voodoo Chile.

COMPRESSOR: Our simulation is based on the well-known MXR Dyna Comp. 

A compressor limits the dynamic range of a signal, in that the signal level is 

reduced as soon as a pre-determined threshold is exceeded. A compressor 

lets you achieve noticeable and creative sound effects. How strongly the 

compressor kicks in is controlled using ADJUST, allowing you to achieve 

apparent sustain). When ADJUST is turned all the way to the left, the compressor 

function is deactivated. 
The second parameter (attack) controls the amount of time that the compressor 

needs to react, once the threshold has been exceeded. If you set up a short attack 

time, the compressor will react very fast.
NOISE GATE: Noise gates are used to remove or reduce noise or other 

interference. Guitar signals in particular are very sensitive to interference. 

Not only do guitarists often use high-gain settings but guitar pick-ups can 

amplify unwanted inter-ference. This can be painfully apparent during breaks 

in the music. And how does a noise gate work? It simply mutes the signal during 

breaks, eliminating any interference at the same time.
The ADJUST control determines, when the noise gate starts processing. 

This control lets you decide if you want to suppress background noise more or 

less pronouncedly. When ADJUST is turned all the way to the left, the noise gate 

function is deactivated. 
The second parameter (release) determines the time that the noise gate remains 

open after it had fallen below the threshold. If you set up a short release 

time, this means that the noise gate will suppress the signal very soon after it 

detects noise.

The reverb is still one of the most important effects in a mix or at a live event. 

BEHRINGER offers you four different reverb programs, so that you can always find 

the kind of reverb that fits your excact situation:
Ambience: short room simulation without reverb tail.
Cathedral: a long, rich reverb, like in a cathedral.
Spring: typical sound of a classic spring reverb.
Reverb: universal, warm reverb simulating a concert hall.
ADJUST controls the reverb intensity, while the second parameter 

determines decay.

A/DA, Boss, DyTronics, Electro Harmonix (EHX), MXR, Digitech, Vox as well the names of musicians and 
bands are registered trademarks of their respective owners and are in no way associated with BEHRINGER. 
The brand names appearing here are mentioned solely to describe the character of sounds and effects created 
in the X V-AMP.