NEC M260X User Manual

2. Projecting an Image (Basic Operation)

 After Use

Preparation: Make sure that the projector is turned off.

1. Unplug the power cord.

2. Disconnect any other cables.

• Remove the USB memory if it is inserted into the projector.

3. Retract adjustable tilt foot if extended.

• Do not touch the lens.

4. Slide the lens cover to the right to cover the lens.

Short-throw model (M350XS/M300XS/M260XS/M300WS/
M260WS)
① Place each catch on the bottom of the lens cap into two grooves of

the projector.

② Push the top of the lens cap to cover the lens.

5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from

damage.

Insert the projector with the lens
facing upward

NOTE:

• When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to the projec-

tor.

• The M420X, M420XV, M350XS, M300XS, M260XS, M300WS, and M260WS do not come with a soft case.

CAUTION:

Use caution when putting the projector in the soft case immediately after the projector has been operating. The
projector cabinet is hot.