Kenwood TM-271E User Manual

30

• Memory Channel numbers L0/U0 ~ L2/U2 {page 40}, Pr

{page 43}, and AL (Weather Alert) {page 36} (K market
models only) are reserved for other functions.

5 Turn the Tuning control or press Mic [UP]/[DWN] to

select the Memory Channel in which you want to
store the data.

6 Press [MR] to store the data to the channel.

Some repeaters use a pair of reception and transmission
frequencies with a non-standard offset.  If you store 2
separate frequencies in a Memory Channel, you can
operate on those repeaters without programming the
offset frequency and direction.

1 Store the desired reception frequency and related

data by following steps 1 to 6 given for simplex or
standard repeater frequencies {page 29}.

2 Turn the Tuning control or press Mic [UP]/[DWN] to

select your desired transmission frequency.

3 Press [F].

4 Turn the Tuning control or press Mic [UP]/[DWN] to

select the pre-programmed reception Memory
Channel in which you want to store the data.

5 Press [MR] (1s).

• The transmission frequency is stored in the Memory

Channel.

Note:
◆ When you recall an odd-split Memory Channel, “+” and “–” appear

on the display.  To confirm the transmission frequency, press
[REV].

◆ Transmit offset status and reverse status are not stored in

odd-split Memory Channels.

1 Press [MR] to enter Memory Recall mode.

• The Memory Channel last used is recalled.

2 Turn the Tuning control to select your desired

Memory Channel.

• You cannot recall an empty Memory Channel.

• To restore VFO mode, press [VFO].