Kenwood TM-271E User Manual
50
10
DUAL TONE MULTI-FREQUENCY (DTMF) FUNCTIONS
This transceiver provides you with 10 dedicated DTMF
Memory Channels. You can store a DTMF number (16
digits max.) in each of these channels to recall later for
speed dialing.
Memory Channels. You can store a DTMF number (16
digits max.) in each of these channels to recall later for
speed dialing.
Many repeaters in the U.S.A. and Canada offer a service
called Autopatch. You can access the public telephone
network via such a repeater by sending DTMF tones. For
further information, consult your local repeater reference.
called Autopatch. You can access the public telephone
network via such a repeater by sending DTMF tones. For
further information, consult your local repeater reference.
MANUAL DIALING
The keys on the Mic keypad function as DTMF keys; the
12 keys found on a push-button telephone plus 4
additional keys (A, B, C, D).
12 keys found on a push-button telephone plus 4
additional keys (A, B, C, D).
To perform Manual Dialing, follow the steps below.
1 Press and hold Mic [PTT] to transmit.
2 While transmitting, press the keys in sequence on the
keypad, to send the DTMF tones.
• The corresponding DTMF tones are transmitted.
)
z
H
(
.
q
e
r
F
9
0
2
1
6
3
3
1
7
7
4
1
3
3
6
1
7
9
6
1
2
3
A
0
7
7
4
5
6
B
2
5
8
7
8
9
C
1
4
9
0
#
D
• When DTMF TX Hold is activated {page 51}, you do not
need to continuously press Mic [PTT] to remain in
transmission mode. However, transmission mode is
retained for only 2 seconds after pressing a key, so if the
next key is not pressed within this time limit, the
transceiver stops transmitting.
transmission mode. However, transmission mode is
retained for only 2 seconds after pressing a key, so if the
next key is not pressed within this time limit, the
transceiver stops transmitting.
DTMF M
ONITOR
When pressing the Mic DTMF keys, you will not hear
DTMF tones emitted from the speaker. However, you
can monitor the DTMF tones if desired.
DTMF tones emitted from the speaker. However, you
can monitor the DTMF tones if desired.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 33 (DT.M).
2 Press [MENU] and turn the Tuning control to select
“ON” or “OFF” (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.