FIELD CONTROLS 46474000 User Manual

 

Page 2

1.  Disconnect power to the appliance. 

2.  Mount the ADA-1 in a location near the appliance damper, where the appliance damper control cable will reach the 

receptacle inside the ADA-1, and where the ADA-1 damper cable will reach the damper, by installing screws through 
the back of the ADA-1.  

WARNING:  DO NOT INSTALL SCREWS INTO A RACEWAY OR OTHER ENCLOSURE ON THE APPLIANCE WHERE 
ELECTRICAL WIRING MAY BE PRESENT!   

WARNING:  DO NOT OBSTRUCT ANY CAUTION OR WARNING LABLES ON THE APPLIANCE! 

3.  Disconnect the appliance damper control cable, and reconnect it to the receptacle inside the ADA-1, using an 

appropriate knockout on the ADA-1.  Use care to align the groove in the plug with the spline in the receptacle.  If the 
damper control cable does not have a knockout hole strain relief, use the one provided with the ADA-1. 

4.  Connect the ADA-1 damper cable to the automatic damper, using care to align the groove in the plug with the spline 

in the receptacle.  If the automatic damper has a strain relief bracket, use the strain relief provided with the ADA-1. 

5.  Connect the 24V ADA-1 control cable to the combustion air/venting equipment being installed, by connecting the 

three fork terminals marked T1, T2, and T3 (orange, black, and yellow respectively) to the corresponding T1, T2, and 
T3 terminals on the equipment being installed.  Use an extra strain relief or plastic bushing if none is provided with the 
equipment. 

6.  To complete the installation, complete the line-voltage wiring to the combustion air/venting equipment being installed, 

following the installation instructions for the particular equipment.  Be sure to replace all wiring covers. 

7.  Complete the checkout procedure for the equipment being installed, following the instructions for the particular 

equipment. 

 

P/N 46474000 10/04