Sennheiser EK 2000 User Manual

Page of 43
35
Accessories
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Accessories
The following EK 2000 accessories are available from your specialist
dealer:
009950
BA 2015 accupack
009828
L 2015 charger
009827
DC 2 power adapter for external DC powering (12 V)
009986
CA 2 camera adapter
005022
CL 1 line cable (jack to jack, balanced)
087047
CL 500 line cable (XLR-3 to jack, balanced)
Audio signal is 
distorted
Transmitter sensitivity 
is adjusted too high
Adjust the transmitter 
sensitivity correctly 
(see the instruction manual 
of the transmitter).
Receiver’s audio output 
level is adjusted too 
high
Reduce the audio output level 
(“
AF Out
”, see page 24).
No access 
to a certain 
channel 
During scanning, 
an RF signal has been 
detected on this 
channel and the 
channel has been locked
Set the transmitter operating 
on this channel to a different 
channel and redo the 
frequency preset scan 
(see page 22).
During scanning, a 
transmitter of your 
system operating on 
this channel has not 
been switched off
Switch the transmitter off and 
redo the frequency preset scan 
(see page 22).
Problem
Possible cause
Possible solution