Graco 447-4-02 User Manual
© 2002 Graco 447-4-02
Adjustable Infant Restraint Base
See infant restraint owner’s manual for
complete installation instructions.
Base with LATCH
!
You must read and understand both the owner’s
manual from the infant restraint and these
instructions before using the infant restraint and
base. Keep this sheet with the instruction booklet
in the pocket of your infant restraint for reference.
!
This base can only be used with a Graco
®
Infant Restraint.
!
If you do not have instructions for your infant
restraint or if you have any questions about
your product, call Graco at 1-888-224-6549 or
visit our website at www.gracobaby.com.
ecline the infant restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of teps in
your infant restraint owner’s
your infant restraint owner’s
The adjustable base is used along with the level indicator on the side of your infant restraint. To check the proper angle of
the infant restraint, first make sure the vehicle is on level ground and that the infant restraint/base is not tilted sideways on
the vehicle seat. Then check the level indicator. You must look straight on at the indicator.
the infant restraint, first make sure the vehicle is on level ground and that the infant restraint/base is not tilted sideways on
the vehicle seat. Then check the level indicator. You must look straight on at the indicator.
If the indicator shows ONLY blue, the infant restraint is properly leveled.
If any orange is showing in the level indicator, the infant restraint is
either too upright or too reclined.
either too upright or too reclined.
To lower the foot: pull down on the bottom of the foot to the desired
setting to adjust the recline
.
To raise the foot: set the base on a flat surface, push in on the fingers
on the base and push down on the base to adjust the recline
.
If there is still orange in the level indicator when the foot is completely
extended then place a rolled towel under the foot until ONLY blue shows.
Tighten belt through base, then reinstall infant restraint. Level indicator
should now show ONLY blue—if you still see orange, re-adjust recline
.
Your new infant restraint base is equipped with Graco’s recline adjustment foot, which helps to properly recline the infant
restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of the steps in your infant restraint owner’s
manual.
restraint/base on the vehicle seat. Use it AFTER you have carefully followed all of the steps in your infant restraint owner’s
manual.
Storing LATCH
1. For ease of storing, extend LATCH
to its maximum length
.
2. Locate the storage bars on bottom of
infant restraint base
.
3. Fasten end of LATCH (without
adjustment belt) onto storage bar
.
4. Repeat Step 3 for LATCH with
adjustment belt. After fastening onto
storage bar, pull on adjustment belt to
make sure LATCH is securely fastened
.
5. LATCH storage should look like this
when complete
.
Storage bars
Underside of Base
1
4