Golden Technologies GP600 CC User Manual

Page of 40
Compass Owner’s Manual – Models: GP600 SS, GP600 CC  
                                                                                                                            Revised 05/23/13 
 
 
 
 
31
BATTERY CHARGING 
 
CHARGING THE BATTERIES  
Your Compass’s charging system is designed for your safety and for your convenience.  
Follow the steps below to recharge the batteries.  
1. Position your Compass
 
close to a standard wall electrical outlet.  
2. Turn off the power on the joystick.  
3. Remove the charger from the SEAT POCKET. See figure 24.  
4. Insert the matching charger plug into the joystick’s charging socket that is located at 
the front of the joystick. See figure 25. 
 
NOTE: MAKE SURE THE STANDARD ELECTRICAL OUTLET YOU ARE USING IS NOT 
CONTROLLED BY A LIGHT SWITCH CAUSING THE CHARGER TO SHUT OFF WHEN 
IT IS ACTIVATED. 
 
5. Insert the plug at the other end of the charger power cord into a standard electrical 
wall outlet.  
6. Disconnect the charger power cord from the wall outlet and from the joystick charging 
socket when the batteries are fully charged. 
  
 
NOTE: The batteries will be fully charged in approximately eight hours. A full charge is 
indicated when the green light on the battery charger side panel turns on and all 8 
joystick LEDs are lit when joystick is turned on. 
 
  
        
           
                       
                      Figure 24                                                   Figure 25  
 
 
 
 
 
 
 
Charging Socket