Garmin handlebar base 550 User Manual

Warning: The terms of the Garmin Warranty require that the power cable with bare wire leads be 

installed by experienced installers having the proper knowledge of automotive electrical systems and 

skill in the use of special tools or hardware required for installation.

Select a suitable and secure location to mount the zūmo on your motorcycle based on available 

power sources and safe cable routing.

Standard jacks for microphone (2.5 mm) and audio out (3.5 mm) are located on the left side of 

the mount (under a weather cap). When connecting your audio system to the zūmo, be sure to 

consider the pathways needed to route the necessary cables. For information about hands-free 

audio and phone options, refer to the zūmo 500/550 Quick Reference Guide and the zūmo 500/550 

Owner’s Manual on disk. 

The zūmo includes parts for two handlebar installation solutions. Custom mounts can require 

additional hardware (www.ram-mount.com).

1.  Place the U-bolt around the handlebar, and thread

the ends through the handlebar base.

2.  Tighten the nuts to secure the base. Do not

overtighten.

note: Both 1/4” standard and M6 

bolts are included. Match the size of 

the factory bolts on your clutch/

brake clamp bracket.

1.  Remove the two factory bolts on your

clutch/brake clamp bracket.

2.  Thread the new bolts through the

handlebar base, spacers, and clamp

bracket.

3.  Tighten the bolts to secure the base.

Garmin

®

 is a registered trademark and zūmo

™

 is a trademark of Garmin Ltd. or its subsidiaries and may 

not be used without the express permission of Garmin. 

October 2006 

Part Number 190-00697-03 Rev. C 

Printed in Taiwan