Garmin stylus n11 User Manual
Start Here
3
Squeeze the edge guide and slide it to the left.
4
Load paper against the right edge guide and behind the
tab, with the printable side face up.
tab, with the printable side face up.
4 x 6
8½ x 11
Note:
Don’t load the paper sideways; always load it short
edge first.
5
Slide the edge guide over, against the left edge of
the paper.
the paper.
Read these instructions before using your printer.
1
Unpack
Power cord
Caution:
Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
3
Install ink cartridges
1
Open the printer cover.
Caution:
Do not touch the white cable inside the printer.
2
Shake the ink cartridges, then unpack them.
3
Remove only the yellow tape from each cartridge.
Caution:
Don’t remove any other seals from the cartridges.
4
Insert the cartridges in the holder for each color, and press
each cartridge down until it clicks.
each cartridge down until it clicks.
5
Close the printer cover.
6
Press the
stop button to charge the ink. Charging takes
about 2 minutes.
Note:
Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution:
Don’t turn off the printer while it is charging or you’ll
waste ink.
4
Load paper
1
Open the paper support, then pull up the extension and tilt
it back slightly.
2
Insert the output tray.
Epson Stylus
®
N10/N11 Series
*411842900*
*411842900*