Grizzly g0462 User Manual
g0462 Wood Lathe (mfg. since 3/10)
-9-
110v Operation
SEcTION 2: cIRcUIT REQUIREMENTS
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. compliance MUST
be verified by a qualified
electrician!
full Load Amperage Draw
this machine draws the following amps under
maximum load:
maximum load:
Amp draw .............................................. 14 Amps
power Supply circuit Requirements
the power supply circuit for your machine must
be grounded and rated for the amperage given
below. never replace a circuit breaker on an exist-
ing circuit with one of higher amperage without
consulting a qualified electrician to ensure compli-
ance with wiring codes.
be grounded and rated for the amperage given
below. never replace a circuit breaker on an exist-
ing circuit with one of higher amperage without
consulting a qualified electrician to ensure compli-
ance with wiring codes.
If you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, con-
sult a qualified electrician.
minimum Circuit size .............................20 Amps
power connection Device
the model g0462 comes prewired with a nemA
5-15 plug, as shown in
5-15 plug, as shown in
figure 2.
Grounding Prong
Neutral Hot
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
figure 2. nemA 5-15 plug and receptacle.
Extension cords
using extension cords may reduce the life of the
motor. instead, place the machine near a power
source. if you must use an extension cord:
motor. instead, place the machine near a power
source. if you must use an extension cord:
•
use at least a 14 gauge cord that does not
exceed 50 feet in length!
exceed 50 feet in length!
•
the extension cord must also have a ground
wire and plug pin.
wire and plug pin.
•
A qualified electrician must size cords over
50 feet long to prevent motor damage.
50 feet long to prevent motor damage.