Bosch shu 3030 User Manual

Dishwashers may exhibit problems that are unrelated to a malfunction of the dishwasher itself. The
following table may serve to answer your question about a problem you are having without having to
call a repair person.

Rinse-aid dispenser is empty. Fill rinse-aid dispenser.

A fuse may have blown or a circuit breaker tripped. Replace fuse or

reset circuit breaker at your fuse box/breaker box.

Door of dishwasher not properly closed. Close dishwasher making

sure that door latches.

Dishwasher runs a long If the dishwasher completes the cycle, but the run time seems
time

exceptionally long it is probably due to cold incoming water. To avoid
this problem it is recommended that before starting the dishwasher:
open the hot water faucet at the sink nearest the dishwasher and
run the water until it runs hot. Then turn off the water and start the
dishwasher.

Water line is closed or inlet filter is blocked. Open water valve and/or

check inlet filter.

Kink in drain hose. Filter clogged. Kitchen sink clogged. Air gap (type

installed at sink) clogged. Check drain hose and fine and coarse
filters (see section titled CARE and CLEANING). Check kitchen sink to
make sure it is draining well. If problem is kitchen sink not draining
you may need a plumber rather than a serviceman for the dishwasher.

A program was not completely finished.

lid will not close
Lower spray arm does Remove lower spray arm  and clean arm and spray arm mounts.
not  rotate freely
White deposits left on

Too little rinse-aid.

Too much rinse-aid used.

Utensils  not properly arranged.

Incorrect  type of detergent used. Use only automatic dishwasher
detergents.

• Incorrect amount of detergent or rinse agent.

• Utensils incorrectly arranged or rack overloaded.
• Wash arm rotation blocked by utensils.
• Filters not properly fitted into position.
• Clogged nozzles in wash arm(s)
• Unsuitable program selected.