Crestron cnmsx User Manual

Crestron CNMSX 

Integrated Control System

 

As of the date of manufacture, the unit has been tested and found to comply with 
specifications for CE marking. 

 

NOTE:  This device complies with part 15 of the FCC rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may cause 
undesired operation.  

WARNING:  To prevent bodily injury when mounting or servicing this unit in a 
rack, take special precautions to ensure that the system remains stable.  The following 
guidelines are provided to ensure your safety: 

 The unit should be mounted at the bottom of the rack if it is the only unit in the 

rack. 

 When mounting this unit in a partially filled rack, load the rack from the bottom 

to the top with the heaviest component at the bottom of the rack. 

 If the rack is provided with stabilizing devices, install the stabilizers before 

mounting or servicing the unit in the rack. 

 

NOTE:  If rack mounting is not required, rubber feet are provided for table-top 
mounting or stacking. Apply the feet near the corner edges on the underside of the 
unit.  

NOTE:  Reliable earthing of rack mounted equipment should be maintained.  
Particular attention should be given to supply connections other than direct 
connections to the branch circuit. (e.g., use of power strips). 

Two “ears” are provided with the CNMSX so that the unit can be rack mounted. 
These ears must be installed prior to mounting. Complete the procedure below to 
attach ears to CNMSX. The only tool required is a #2 Phillips screwdriver.  

1.  There are 12 screws (#6-32 x 0.375" LG) that secure the sides of the 

CNMSX top cover.  Using a #2 Phillips screwdriver, remove the three 
screws closest to the front panel from one side of the unit.  

2.  Position a rack ear so that its mounting holes align with the holes 

vacated by the screws in step 1.  

3.  Secure the ear to the CNMSX with three screws from step 1, as shown 

on the next page.  

•  11