Clarion nax983hd User Manual

NAX983HD

• If the vehicle is too close to the destination. 

In this case, a message to inform you about 
this will be displayed.

• If it is impossible to reach the destination or 

waypoints because of traffic regulations, 

etc.

• If the map database does not contain the 

area data of the selected locations.

• If only an extremely roundabout route is 

available to reach the destination or 
waypoints.

• When displaying a route, the following may 

occur:

• Even if a route calculation is requested on a 

main road, the start point of the suggested 
route may not exactly match the current 
vehicle location.

• If a route calculation is requested on a main 

road, the end point of the suggested route 
may not exactly match the destination.

• If a route calculation is requested on a main 

road, the system may suggest a route 
starting from another main road.
In this case, park the vehicle in a safe 
location and reset the vehicle mark using 
Setting menu, or continue driving until the 
vehicle icon appears on a main road. If 
either of these methods are not successful, 
request a route calculation again.

• Ferry lines are stored in this system. Take 

into consideration the travel time required 
and operational condition before deciding 
whether to use them or not.

• The current location or the travelling direction 

may shift according to the travelling condition. 
It is not a malfunction, and will return to a 
normal display when keeping travelling for a 
while. 

• Though the vehicle position may shift in places 

other than the road such as in the parking lot, 
etc., it is not a malfunction. It will return to a 
normal display when travelling on an actual 
road for a while.

• In the current location display, a representative 

name of the place which is nearest to the 
vehicle position in the map database is 
displayed, it may be different from the actual 
place name.

• The voice guidance may not match the actual 

roads or regulations. The cause of this can be 
that the actual roads and the data in the map 
database are different, or the vehicle speed.

• If the content of the voice guidance does not 

match the actual roads or regulations, follow 
the information acquired from the actual traffic 
or road signs.

• The voice guidance is activated only for 

intersections with certain conditions. There 
may be cases that the vehicle has to turn, but 
the voice guidance is not activated.

• The content of the voice guidance may vary, 

depending on the direction of the turn and the 
type of the intersection.

• The voice guidance timing will vary depending 

on the situation.

• The voice guidance is not available when the 

voice guidance function is not set to ON. 
Moreover, even when the voice guidance 
function is set to ON, if the voice guidance 
volume is set to a very low value, the voice 
guidance may not be audible. 

➜ “Volume/ 

Voice Settings” (P. 52)

• The voice guidance will start when the vehicle 

enters the suggested route. Before entering the 
route, refer to the map screen for directions.

• When the vehicle approaches a waypoint, the 

voice guidance will say “You have arrived at 
waypoint <1 to 5>”. The voice guidance will 
switch to the next route section. Please refer to 
the map screen for directions until the next 
voice guidance is started.

• When the vehicle approaches a destination, 

the voice guidance will say “You have arrived 
at the destination”. For the remainder of the 
way, please refer to the map screen for 
directions.