Crestron pmk-4l User Manual

 

Pre-Construction Mount Kit: PMK-4L 

The PMK-4L is a pre-construction mount kit for the 
Crestron Isys

®

 TPS-4L and TPMC-4L wall mounted 

touchpanels. The PMK-4L is used for installation on a 
stud. For custom touchpanel placement without a stud, 
use the TMK/WMKT-4L, MMK/WMKM-4L or the 
WMKB-4L. The PMK-4L includes a 12-inch long, 18 
AWG jumper wire to secure touchpanel cabling prior to 
drywall installation and to avoid damaging the cables 
when the opening is routed. Refer to the physical views 
(bottom, side, and front) of the PMK-4L, shown after this 
paragraph. The table that follows lists all parts included 
with the PMK-4L. 

NOTE:  This mounting kit is to be used only with the 
TPS-4L and TPMC-4L wall-mounted series of 
touchpanels. 

FOR
DRYWALL
NAILS
(NOT
INCLUDED)

FOR DRYWALL NAILS (NOT INCLUDED)

FOR DRYWALL SCREWS (NOT INCLUDED)

5.55 in

14.01 cm

6.00 in

15.24 cm

8.37 in

21.56 cm

0.30 in

0.76 cm

4.50 in

11.43 cm

SECURE 18 AWG
JUMPER WIRE IN
NOTCH TO HANG
CABLES AWAY FROM
CUTTING TOOLS

 

Metal, Plate, Pre-Construction

2013238

1

Cover Plate

2013239

1

Screw, #04-40, 1-1/2”L, Pan, Phil 

2007190

4

Jumper wire, 12”L, 18AWG, Black

2007838

1

 

The PMK-4L consists of a single metal plate, which 
fastens to the stud of a framed wall prior to hanging 
drywall (shown after this paragraph). Standard drywall 

nails or screws to attach the PMK-4L are not supplied 
(length can vary). 

 

The plate is designed to provide the necessary support for 
a single touchpanel and can mount to the right or left side 
of a stud. Confirm that the PMK-4L is level before 
applying drywall. A rectangular opening with the 
dimensions shown in the illustration after this paragraph 
must be made in the drywall. Verify that the opening 
exposes the #04-40 tapped holes in each corner. 

5.60 in

14.22 cm

4.16 in

10.57 cm

3.66 in

9.30 cm

1.30 in

3.30 cm

 

If the opening is too large, two pre-construction 
accessories are available to make adjustments. Use the 
optional TMK-4L (Trim Ring Kit) to provide a smooth 
edge at the opening. This option provides a finished 
appearance and is preferred with wallpaper. Use the 
optional MMK-4L (Mud Ring Kit) to fill in larger 
irregularities around the opening (requires plastering).  

Complete the installation by either installing the 
touchpanel, leaving the hole open (if permitted by local 
building codes), or installing the supplied cover plate with  
the included #04-40 x 1½” screws (shown after this 
paragraph). If the touchpanel is to be installed, refer to the 

 

 

15 Volvo Drive   Rockleigh, NJ 07647

 

Tel: 888.CRESTRON

   

Fax: 201.767.7576

Specifications subject to 

www.crestron.com

change without notice.