ICOM IC-R1500 User Manual
9
3
SETTING A FREQUENCY
■
Tuning step selection
When using the tuning dial to change the frequency, or when
a scan function is activated, the frequency changes in incre-
ments determined by the set tuning step. This can be
changed if desired.
a scan function is activated, the frequency changes in incre-
ments determined by the set tuning step. This can be
changed if desired.
The following tuning step are available.
• 0.01 kHz (10 Hz)
• 0.02 kHz (20 Hz)
• 0.05 kHz (50 Hz)
• 0.1 kHz (100 Hz)
• 0.5 kHz (500 Hz)
• 1 kHz
• 2.5 kHz
• 5 kHz
• 6.25 kHz
• 8.33 kHz
• 9 kHz
• 10 kHz
• 12.5 kHz
• 15 kHz
• 20 kHz
• 25 kHz
• 30 kHz
• 50 kHz
• 100 kHz
• 125 kHz
• 150 kHz
• 200 kHz
• 500 kHz
• 1000 kHz (1 MHz)
q
Push [V/MHz•SCAN] to select VFO mode, if necessary.
w
Push [TS•MODE] to enter tuning step select mode.
e
Rotate [DIAL] to select the desired tuning step.
r
Push any key to exit tuning step select mode.
■
Setting a frequency
q
Rotate [DIAL] to set the frequency.
• If VFO mode is not selected, push [V/MHz•SCAN] to select VFO
mode.
• The frequency changes in the selected tuning steps.
w
To change the frequency band or tune in 1 MHz (10 MHz)
steps, push [V/MHz•SCAN], then rotate [DIAL].
steps, push [V/MHz•SCAN], then rotate [DIAL].
• Pushing and holding [V/MHz•SCAN] for 1 sec. starts scan func-
tion. If scan starts, push [V/MHz•SCAN] again to cancel it.
While the band selection mode is selected,
the digits below 100 kHz disappear.
the digits below 100 kHz disappear.
While 10 MHz tuning step is
selected, the 10 MHz digit
blinks.
selected, the 10 MHz digit
blinks.
While 1 MHz tuning step is
selected, the 1 MHz digit
blinks.
selected, the 1 MHz digit
blinks.
[DIAL]
[V/MHz•SCAN]
[DIAL]
[TS•MODE]