ICOM FP-561 User Manual

19

2

r

PLOTTER MODE

q

COASTLINE DATA MANIPULATION

Å

The distance and azimuth that can be measured are between the ship mark and

the cursor position or between two points specified with the cursor.

q

Press the [UP]/[DOWN] or [LEFT]/[RIGHT] key to activate the cross hair cursor

(in light blue).

The cursor position is indicated at the lower left of the screen.

* When the cross hair cursor is activated, the auto ship-centering mode is can-

celed.

w

Using the [UP]/[DOWN] or [LEFT]/[RIGHT] key, move the cross hair cursor to the

desired position.

Using the [UP]-[LEFT] or [UP]-[RIGHT] key combination allows you to move the

cross hair cursor to the upper left of right.

Using the [DOWN]-[LEFT] or [DOWN]-[RIGHT] key combination allows you to

move the cross hair cursor to the lower left or right.

* When the cross hair cursor reaches a screen edge, the coastline image is

scrolled.

e

The distance between the ship mark and the cursor position and the azimuth of

the cursor position relative to the ship mark are displayed in the cursor position

field.  When the ship mark coincides with the cursor position, a message indi-

cating the ship reaches the cursor position is displayed in this field.

GPS   34ﾟ 18. 000N  135ﾟ 01. 000E

6

Cursor position field where 
the distance and azimuth 
between the ship and the 
cursor position are displayed

80.0

 FT

0°T  12KT  54.3°F

34°20.000N

135°02.500E

 27°

  2.35

    NM

  0:15

RANGE 8

80.0

 FT

0°T  12KT  54.3°F

GPS   34ﾟ 18. 000N  135ﾟ 01. 000E

6

Cursor position field where 
the distance and azimuth 
between two points are displayed

Subcursor

34°21.000N

135°04.400E

 60°

  1.93

    NM

  0:12

RANGE 8

q

Press the [UP]/[DOWN] or [LEFT]/[RIGHT] key to activate the cross hair cursor

(in light blue).

w

Using the [UP]/[DOWN] or [LEFT]/[RIGHT] key, move the cross hair cursor to the

desired first point.

e

Press the [SET] key.

The first point (subcursor position) turns red.

The distance and azimuth readings in the cursor position field will also turn red.

r

Using the [UP]/[DOWN] or [LEFT]/[RIGHT] key, move the cross hair cursor (light

blue) to the desired second point.

* Pressing the [SET] key causes the subcursor to turn light blue, allowing you to

change the subcursor position.

t

The distance between the two points and the azimuth of the light blue cursor rel-

ative to the red subcursor are displayed in the cursor position field.

y

When you finish measurement, press the [CLR] key.

The subcursor will go off.

ı