INSTEON 2442-522 (aus-nz) User Manual
Page 12 of 24
2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM
Error Blink
Default = enabled
This setting is only adjustable via software or a central controller. Micro module LED will blink red once for
a few seconds if one or more responders do not acknowledge a message and will blink green once if all
responders are successful.
This setting is only adjustable via software or a central controller. Micro module LED will blink red once for
a few seconds if one or more responders do not acknowledge a message and will blink green once if all
responders are successful.
Blink on Traffic
Default = disabled
This setting is only adjustable via software or a central controller. Micro module LED will blink red if it
detects noise that could disrupt communication.
This setting is only adjustable via software or a central controller. Micro module LED will blink red if it
detects noise that could disrupt communication.
Beep on Button Press
Default = disabled
This setting is only adjustable via software or a central controller. Micro module will beep every time its
connected switch is tapped or a button is pressed.
This setting is only adjustable via software or a central controller. Micro module will beep every time its
connected switch is tapped or a button is pressed.
Programming Lock
Default = disabled
This setting is only adjustable via software or a central controller. When enabled, Programming Lock will
disable the set button so that a user can not adjust settings or modify links. This is typically used in
commercial or installer applications.
This setting is only adjustable via software or a central controller. When enabled, Programming Lock will
disable the set button so that a user can not adjust settings or modify links. This is typically used in
commercial or installer applications.
INSTEON Setup
Some products have subtle differences in their setup procedures. Please refer to the other devices’
owner’s manuals for details.
owner’s manuals for details.
INSTEON Controllers, Responders and Links
• The INSTEON “transmitter” is called a controller
• The INSTEON “receiver” is called a responder
• The association between the controller and responder is called a link
• The INSTEON “receiver” is called a responder
• The association between the controller and responder is called a link
Note that a link is one way. If you wish to have control “the other way,” simply add a link “the other way.”
Controller
Responder
Link