Lennox akm-lsm lsm40st-pv User Manual

HEARTH PRODUCTS

KITS AND ACCESSORIES

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Step 1.  If applicable, remove the mesh pull screens, as follows: 
 

Lift up the left side of the screen rod and slide it to the LEFT until 

the right side of the rod is disengaged from the hole. Slowly 

remove the rod and firescreens from the fireplace. Set aside in a 

safe location for later reinstallation.

Step 2.  Remove the glass door assembly, as follows:

a.  See Figure 2. While holding the top of the glass door frame 

in place, use a Phillips screwdriver to remove the two (2) 

screws securing the door frame to the two (2) door latches.

b.  Carefully swing the top of the glass door frame outward (as 

shown in Figure 2), and then lift the door assembly up and 

out of its lower track.

c.  Carefully set aside the glass door assembly in a safe location 

(on a padded surface) for later reinstallation.

(2) ea. Andirons
(4) ea. Thumbscrews (2 attached to each andiron)

Phillips screwdriver

TM

• The surfaces on your fireplace get EXTREmELY HOT!
• The glass on the front of the fireplace reaches EXTREmELY

  high emperatures and can cause severe burns if touched. Even after 

• Keep children away from an operating fireplace. Closely supervise 

•  Never operate fireplace with glass door assembly removed.
•  Securely  tighten  door  latch  screws  when  reinstalling  glass  door 

•  Handle glass door assembly with extreme care. Replace damaged 

  The door assembly on this fireplace contains ceramic glass. Handle with 

care to prevent damage. If the door frame or glass becomes  damaged, 

replace the entire glass door assembly with a manufacturer-approved 

replacement assembly only. Do not attempt to substitute any materials 

used on this door assembly or replace cracked or broken glass with 

any other materials. 

• Read all steps before starting installation.
• These instructions must be left with the appliance.
• All warnings, precautions, and instructions in the Installation 

Instructions and Care and Operation Instructions provided 

with the appliance also apply to these instructions.

• If you encounter any problems, need clarification of these

instructions, or are not qualified to properly install this kit, 

contact your local distributor or dealer.

These decorative andiron kits are offered in two attractive styles as an 

enhancement to the firebox appearance.