Lantronix 900-422 User Manual

Page of 116
 
XPress DR+ User Guide 
103 
Appendix A: Technical Specifications 
Table 13-2. XPress DR+ and XPress DR+W Specifications 
Category 
Description 
CPU 
Lantronix DSTNI-EX 48 MHz clock 
Internal CPU Memory 
256 KB SRAM 
Flash 
2 MB Flash 
EEPROM 
2 KB EEPROM 
Serial Interface  
2 RJ45 RS232 Serial Ports  
Baud rate selectable from 300 to 230 Kbaud 
1 Screw terminal RS-422/485 interface on Serial Port 2 (2 and 4 wire support) 
LED indicators for TXD and RXD activities 
Serial Line Formats 
Characters: 7 or 8 data bits 
Stop bits: 1 or 2 
Parity: odd, even, none 
Modem Control 
DTR, DSR 
Flow Control 
Hardware: CTS/RTS 
Software: XON/XOFF 
Reset (warm boot) 
Front panel recessed push button. (This is not a reset to factory settings.) 
Power Input 
Removable screw terminal block connector 
9-30 VDC or 9-24 VAC with chassis ground 
2.3 Watts maximum 
 
Network Interface 
2 RJ45 10Base-T/100Base-TX Ethernet ports 
Embedded unmanaged fully compliant 802.3u non-blocking Ethernet switch  
Store and forward architecture with 1K MAC address lookup table 
Automatic MDI/MDI-X crossover  
Full duplex IEEE 802.3x flow control 
Half-duplex back pressure flow control 
IEEE 802.1d spanning tree
Dimensions  
123 x 57 x 88 mm (4.85 x 2.25 x 3.45 in), terminal blocks included 
Weight  
0.21 kg (0.46 lb) 
Temperature  
Operating range: -40°C to +70° C  (-40 to 158 degrees F) 
Humidity 
20% to 90% relative humidity, non-condensing 
Case 
High-impact plastic case with integrated DIN-rail (35 mm) mount 
IP30 enclosure rating 
Protocols Supported 
ARP, UDP/IP, TCP/IP, Telnet, ICMP, SNMP, DHCP, BOOTP, TFTP, and HTTP 
Installable Industrial 
Protocols 
ModBus TCP, ModBus ASCII/RTU, Multi-Master DF1 
Management 
Internal web server (Standard Tunneling firmware only) 
SNMP (read only) 
Serial login 
Telnet login 
DeviceInstaller software  
System Software 
DeviceInstaller, Windows® 95/98/ME/NT/2000/XP-based configuration software