Lantronix 900-422 User Manual
Chapter 4: XPress DR+W
XPress DR+ User Guide
34
Network Mode (XPress DR+W only)
The first prompt requires you to set the unit for wired or wireless use. Wireless is the
default, so just press Enter at the prompt.
default, so just press Enter at the prompt.
Figure 4-7. Network Mode
The IP Address, Set Gateway IP Address, and Netmask fields display the current
values.
values.
Figure 4-8. Server Settings
IP Address : (000) .(000) .(000) .(000)
Set Gateway IP Address (N)
Netmask: Number of Bits for Host Part (0=default) (0)
Change telnet config password (N)
Set Gateway IP Address (N)
Netmask: Number of Bits for Host Part (0=default) (0)
Change telnet config password (N)
IP Address
If DHCP is not used to assign IP addresses, enter the IP address manually. The IP
address must be set to a unique value in the network. Enter each octet and press Enter
between each section. The current value displays in parentheses.
address must be set to a unique value in the network. Enter each octet and press Enter
between each section. The current value displays in parentheses.
IP Address : (000) (000) (000) (000) _
If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP options.
The following table shows the bits you can manually configure to force the XPress DR+
to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit.
The following table shows the bits you can manually configure to force the XPress DR+
to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit.
Table 4-2. BootP/DHCP/AutoIP options
Options
Bit
Value
AutoIP 0 1
DHCP 1 2
BootP 2 4
For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only
DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.)
This is the most common setting when using DHCP.
DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.)
This is the most common setting when using DHCP.
Set Gateway IP Address
The gateway address, or router, allows communication to other LAN segments. The
gateway address should be the IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within the local network. The default
setting is N (No), meaning the gateway address has not been set. To set the gateway
address, type Y and enter the address.
gateway address should be the IP address of the router connected to the same LAN
segment as the unit. The gateway address must be within the local network. The default
setting is N (No), meaning the gateway address has not been set. To set the gateway
address, type Y and enter the address.
Set Gateway IP Address (N) ? Y
Gateway IP addr (000) (000) (000) (000) _
Gateway IP addr (000) (000) (000) (000) _