Lantronix 900-422 User Manual
Chapter 9: Setup Mode: Channel Configuration
XPress DR+ User Guide
75
Figure 9-3. Hostlist Option
To enable the hostlist:
1. Enter
a
Connect Mode
of 0x20 (2X), where X is any digit. The menu shows you a list
of current entries already defined in the product.
2. To delete, modify, or add an entry, select Yes. If you enter an IP address of 0.0.0.0,
that entry and all others after it are deleted.
3. After completing the hostlist, repeat the previous step if necessary to edit the hostlist
again.
4. For
Retrycounter
, enter the number of times the Lantronix unit should try to make a
good network connection to a hostlist entry that it has successfully ARPed. The range
is 1-15, with the default set to 3.
is 1-15, with the default set to 3.
5. For
Retrytimeout
, enter the number of seconds the unit should wait before failing an
attempted connection. The time is stored as units of milliseconds in the range of
1-65535. The default setting is 250.
1-65535. The default setting is 250.
d) Datagram Type
Directed UDP
When selecting this option, you are prompted for the Datagram type.
Enter 01 for directed or broadcast UDP.
When the UDP option is in effect, the unit never attempts to initiate a
TCP connection because it uses UDP datagrams to send and receive
data.
Enter 01 for directed or broadcast UDP.
When the UDP option is in effect, the unit never attempts to initiate a
TCP connection because it uses UDP datagrams to send and receive
data.
e) Modem Mode
In Modem (Emulation) Mode, the unit presents a modem interface to the attached serial
device. It accepts AT-style modem commands and handles the modem signals correctly.
device. It accepts AT-style modem commands and handles the modem signals correctly.