Nilfisk r 586 User Manual

   

SCRUBTEC R Manual Steering

SCRUBTEC R Manual Steering

SCRUBTEC R Manual Steering

SCRUBTEC R Manual Steering

SCRUBTEC R Manual Steering

To install or rotate brushes on the cylindrical brush head:

 1. Raise the brush deck and turn the key switch “OFF”.

 2. Raise the brush skirt and pull out to remove.  See

figure 11.

 3. Remove thumb screw from brush door.  See figure 12.

 4. Lower door approximately 12 mm and slide door and

hub assembly from brush.  See figure 13.

 5. Slide brush off hub at opposite end.  See figure 14.

 6. Rotate brush or replace.

 7. Slide brush on drive hub and insert door and hub

assembly into brush core.

 8. Raise door and install thumb screw.

 9. Place side skirt on retainer pins and lower in place.

10. Brushes should be rotated after every 20 hours of use.