Konica Minolta ip-432 User Manual
1-3. Operation Environment
9
I Set Up Chapter 1 Summary
Memory: 32 MB min.
CD-ROM drive
Macintosh
Can only be used if the PostScript option is installed.
Operating system: Mac OS 8.x or higher (Mac OS X is not yet supported.)
CD-ROM drive
Network controller
Interfaces used for connection
The following two types of interfaces can be used to connect this printing system and the PC.
Parallel interface (included with the copier)
This interface is used when using this printing system as a local printer.
Only Windows PCs can be connected through this interface and an IEEE1284 parallel cable is
required. Use a parallel cable that has an Amphenol 36-pin male connector at one end.
Parallel interface can be used in compatible, nibble, and ECP mode.
Only Windows PCs can be connected through this interface and an IEEE1284 parallel cable is
required. Use a parallel cable that has an Amphenol 36-pin male connector at one end.
Parallel interface can be used in compatible, nibble, and ECP mode.
Ethernet (included with the copier)
This interface is used when using this printing system as a network printer.
This interface supports the 100Base-TX and 10Base-T standards. The protocols supported are TCP/IP
(LPD/LPR, Peer-to-Peer), IPX/SPX (NetWare), and AppleTalk (EtherTalk), etc..
This interface supports the 100Base-TX and 10Base-T standards. The protocols supported are TCP/IP
(LPD/LPR, Peer-to-Peer), IPX/SPX (NetWare), and AppleTalk (EtherTalk), etc..