Xerox 4213 User Manual
XES COMMAND LANGUAGE MODE
Where to place it
At the start of the job.
Example
To move the % symbol from its current hex location of 25H to a
new location at 7EH, enter:
new location at 7EH, enter:
E
+T,
L
E
S40500FC2500FFX
L
The data record in this example is summarised below.
S
A data record always begins with the letter “S”.
4
4 is used here. The use of other numbers excludes
certain fonts.
certain fonts.
05
Use 05 as the byte count to move one character at
a time.
a time.
00FC2500
The data following the byte count consists of the
the hex values of the character or characters being
assigned.
the hex values of the character or characters being
assigned.
FF
Always put FF at the end of each record. To move
more characters, make additional records.
more characters, make additional records.
X
L
X and
L
together terminate table loading and
should be included after the FF in the last record.
More
The Reset command returns the printer to the default language.
Load Translation Table
Purpose
Loads a special translation table for Laserpage software. This
command performs the same function as the
command performs the same function as the
E
+T
command, but
does not cause a page eject.
Syntax
E
zt
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
2-113