Xerox 4213 User Manual
XES COMMAND LANGUAGE MODE
More
This command takes effect whenever the bypass slot is chosen,
either through the Emulation Menu, or the paper source
selection command (
either through the Emulation Menu, or the paper source
selection command (
E
c9
).
The command remains in effect until either a Reset command or
another paper tray or bypass slot paper size command is
received. The default value is restored after a reset.
another paper tray or bypass slot paper size command is
received. The default value is restored after a reset.
If more than one bypass slot paper size command is entered on
a page, the printer recognises only the last one.
a page, the printer recognises only the last one.
Note: 2-sided printing is not possible with this command.
Offset
Purpose
Offsets sheets in the stacker at specified places in the job.
Syntax
E
o
Where to place it
Before any printable data on the page. If Offset is entered within
the printable contents of the page, it takes effect on the next
page.
the printable contents of the page, it takes effect on the next
page.
More
The default condition for offsetting is set through the printer
control panel. Pages can be offset:
control panel. Pages can be offset:
— At job boundaries with
E
+P
— Upon explicit command (
E
o).
Refer to the Xerox 4213 Laser Printer User Guide for information
on setting the default.
on setting the default.
The printer’s offset feature works like a toggle; that is, each time
either a job control command or an Offset command is entered,
the condition of offsetting is toggled to its opposite state, which
is either enabled or disabled. Thus, it is possible to change the
state of offsetting within a job as many times as desired.
either a job control command or an Offset command is entered,
the condition of offsetting is toggled to its opposite state, which
is either enabled or disabled. Thus, it is possible to change the
state of offsetting within a job as many times as desired.
If you were printing a 2-sided job and included an Offset
command at the top of pages 2, 3, 4, 5, 6, and 7 (2/3, 4/5, and
6/7), no offsetting would appear because of the “toggling” of the
command. If an Offset command were at the top of pages 3, 5,
and 7, then pages 3/4 and 7/8 would offset, and all subsequent
pages in other jobs would also offset.
command at the top of pages 2, 3, 4, 5, 6, and 7 (2/3, 4/5, and
6/7), no offsetting would appear because of the “toggling” of the
command. If an Offset command were at the top of pages 3, 5,
and 7, then pages 3/4 and 7/8 would offset, and all subsequent
pages in other jobs would also offset.
2–24
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE