ZyXEL Communications PLA-400 v2 User Manual
Chapter 6 Powerline Network Setup Tutorial
PLA-4xx Series User’s Guide
61
Figure 44 Adapters on a New Powerline Network
• If you want to access any of your new powerline networks using the PLA-4xx Series
Configuration Utility, change the Network Name on your local adapter to the network
name for the network you want to access. The adapters on that network will then display
in the adapter table, allowing you to select and configure each one.
name for the network you want to access. The adapters on that network will then display
in the adapter table, allowing you to select and configure each one.
6.2 Troubleshooting
The HomePlug (
) LED (light) should light up on your adapter when it successfully
connects to other adapters on your network. If it does not, try the following measures.
• Make sure the adapter is plugged in to a power socket and the power socket is turned on.
• Check you have entered the correct network name for your network.
• Check your powerline adapter is connected to the same electrical circuit as other
• Check you have entered the correct network name for your network.
• Check your powerline adapter is connected to the same electrical circuit as other
powerline adapters on your network.