Kenwood VR 8070 User Manual
47
EN
Remote control unit
Cause
• No setup codes registered for the respective
input(s).
• The remote control is set to a different operation
mode.
• Batteries are exhausted.
• The remote control unit is too far away from
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
or there is an obstacle between the receiver
and the remote.
• No tape or CD is placed in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
to control.
Remedy
• Register a setup code at the respective input(s).
‚
• Press any of the Input Selector keys to select
the appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
• Operate the remote control unit within the
controllable range.
• Place the tape or CD in the source component
which you want to play.
• Wait until recording has completed.
• Press any of the source keys or SRC Power
key to activate the operation mode for the
component you want to control before
operation.
component you want to control before
operation.
·
Symptom
Certain inputs cannot be selected using the
remote control.
remote control.
Remote control operation is not possible.
In case of difficulty
*5453/38-48/EN
04.6.16, 3:48 PM
47