Kenwood TH-G71A User Manual

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

44

The problems described in this table are commonly encountered operational malfunctions.  These types of difficulties
are usually caused by improper hook-up, accidental incorrect control settings, or operator error due to incomplete
programming.  These problems are usually not caused by circuit failure.  Please review this table, and the appropriate
section(s) of this instruction manual, before assuming your transceiver is defective.

  Unmodulated carriers may be received due to internal frequency relationships.

Nothing appears on 
the display when the 
transceiver is 
switched ON, or the 
display is blinking 
ON and OFF. 

1 Low supply voltage

2 If using the optional DC cable:

a) Bad power cable or connections

 

b) Open (blown) power supply fuse 

1 Recharge the battery pack or

replace the batteries.

a) Check the power cable and

connections, then correct/replace
as necessary.

b) Investigate the cause for the

open fuse.  Replace the fuse. 

3, 43

47

—

Most keys and the 
Tuning control do 
not function.

1 Transceiver Lock is ON (Key icon is

visible).

2 The transceiver is in Channel Display

mode.

3 Tone Alert is ON (Bell icon is visible).

1 Press [F] (1 s) to switch OFF

Transceiver Lock.

2 Press [BAND]+ POWER ON to exit

Channel Display mode.

3 Press [F], [7] to switch OFF Tone

Alert.

37

22

38

Memory channels 
cannot be recalled.

There is no data stored in any of the 
memory channels.

Store the desired frequencies in 
memory channels.

18

You cannot select 
the exact desired 
frequency using the 
Tuning control.

The current frequency step size needs to 
be changed.

Select the appropriate frequency step 
size. 

40