Honeywell niagara cp-700 User Manual

WEB-700 WEB-700-O CP-700

95-7776—03

Physical Mounting

The following information applies about physically mounting the unit.

• You can mount the WEB/CP-700 in any orientation. It it not necessary to remove the cover before mounting.

• Mounting on a 35mm wide DIN rail is recommended. The WEB/CP-700 unit base has a molded DIN rail slot and locking clip,

as does the NPB-PWR-UN-H power supply module and any I/O expansion modules. Mounting on a DIN rail ensures accurate

alignment of connectors between all modules.

• If DIN rail mounting is impractical, use screws in mounting tabs on the NPB-PWR-UN-H module and the WEB/CP-700, as well

as any end-connected accessory. Tab mounting dimensions are on the last page of this document.

Fig. 3 and the following procedure provides step-by-step DIN rail mounting instructions for the WEB/CP-700.

Fig. 3. WEB/CP-700 and accessory mounting details.

NOTE: Mount the NPB-PWR-UN-H power supply first, then the WEB/CP-700 controller, then any directly attached I/O

expansion module.

4.1" (104)

5.6"

(142)

3.46"

(88)

11.75" (298)

15.125" (384)

Mounting on

DIN rail

Removing from DIN rail

NPB-PWR-UN-H

DIN rail

end clip

NPB-PWR-UN-H

IO-16-REM-H

WEB/CP-700

Secure controller or last directly

attached I/O module using either

screws or DIN rail end clip (if end

clip does not interfere with 6-

position end connector).