Mitsubishi f9q User Manual
INTRODUCTION
Symbols for Lubrication, Sealants and Adhesives
Information concerning the locations for lu-
brication and for application of sealants and
adhesives is provided, by using symbols, in
the diagram of component parts, or on the
page following the component parts page,
and explained.
: Grease
(multipurpose grease unless there is
a brand or type specified)
: Sealant or adhesive
: Brake fluid, automatic transmission fluid
or air conditioner compressor oil
: Engine oil or gear oil
Maintenance and Servicing Procedures
(1) A diagram of the component parts is
provided near the front of each section in
order to give the reader a better under-
standing of the installed condition of
component parts.
(2) The numbers provided within the diagram
indicate the sequence for maintenance and
servicing procedures.
: Indicates a non-reusable part.
The tightening torque is provided where
applicable.
D Removal steps:
The part designation number corresponds
to the number in the illustration to indicate
removal steps.
D Disassembly steps:
The part designation number corresponds
to the number in the illustration to indicate
disassembly steps.
D Installation steps:
Specified in case installation is impossible
in reverse order of removal steps. Omitted
if installation is possible in reverse order
of removal steps.
D Reassembly steps:
Specified in case reassembly is impossible
in reverse order of disassembly steps.
Omitted if reassembly is possible in reverse
order of disassembly steps.
EXPLANATION OF MANUAL CONTENTS
Classification of Major Maintenance/Service Points
When there are major points relative to maintenance and servicing procedures
When there are major points relative to maintenance and servicing procedures
(such as essential maintenance and service points, maintenance and service stan-
dard values, information regarding the use of special tools, etc.), these are ar-
ranged together as major maintenance and service points and explained in detail.
AA" : Indicates that there are essential points for removal or disassembly.
AA" : Indicates that there are essential points for removal or disassembly.
"AA : Indicates that there are essential points for installation or reassembly.