Crestron mmk-15l wmkm-15l User Manual

Mud Mount Kits 

 

Crestron MMK-15L & WMKM-15L

6.  Use the drywall saw or equivalent to produce a level, rectangular cutout 

in the drywall as shown on page 2. 

7.  Insert the symmetrical mud ring plate into the opening, as shown in the 

illustration after this step. 

FLANGE

HOLES FOR DRYWALL SCREWS
(PROVIDED BY OTHER) SCREW 
LENGTH SHOULD NOT EXCEED
DRYWALL THICKNESS BY 
MORE THAN 1/2".

MINOR ADJUSTMENT OF THE TOUCHPANEL.

THE MOUNTING PLATE ALLOWS FOR ONLY

LEVEL AND CLEAN AS POSSIBLE.

PLEASE MAKE DRYWALL CUTOUT AS

IMPORTANT

MUD RING PLATE

(2013005)

 

8.  Carefully pass the fastener/mounting plate assembly through the 

opening and rest the assembly against the interior surface of the 
drywall. Verify that the fastener plates are between the mounting plate 
and the drywall. 

9.  When the fastener/mounting plate assembly is in position, bend the top 

two flanges of the mud ring upward (approximately 90 degrees) and the 
bottom two flanges downward (approximately 90 degrees). Refer to the 
illustration after this step. 

NOTE:  Fastener/mounting plate assembly will have slight play; this is normal. It 
allows for minor adjustments to the touchpanel during installation. 

 

•  Mud Mount Kits:  MMK-15L & WMKM-15L