caddx nx8-e User Manual
12
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
Step 1
Press [
7
]-[0]. Keypad is now in the “Adjust Tone” mode.
Step 2
Pressing the [1] key will make the keypad sounder go to higher
tones, pressing the [2] key will make the keypad sounder go to lower
tones.
tones, pressing the [2] key will make the keypad sounder go to lower
tones.
Step 3
When the desired tone is reached, press the [#] key to set this tone
and exit from the “Adjust Tone” mode.
and exit from the “Adjust Tone” mode.
CHANGE PARTITION – Optional
Step 1
Press [
7
]-[1].
Step 2
Press a NUMBER key between 1 and 8 to change partitions
momentarily.
momentarily.
Step 3
If no other key is pressed, it will go back to its standard partition in
ten seconds.
ten seconds.
Step 4
If another key is pressed, the system will remain in the new partition
until no keys have been pressed for 60 seconds.
until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1
Press [
7
]-[3]. The zone(s) that created the last alarm will be
displayed on the keypad.
Step 2
The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed during
the last alarm.
alarms and will light steady those zones that were bypassed during
the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
and/or a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
Step 1
Press [
7
]-[4]. The test will be performed as programmed.
Step 2
If the siren test is performed, enter a user code to silence the siren.