rose-displays supersnap with rod, cable clip, and cable and saucer User Manual
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Parts
SuperSnap™ with Rod Connector
Step 1
Place cable into inner channel of
CableClip. The cable should
snap into place. Fig. 1
CableClip. The cable should
snap into place. Fig. 1
Align one end of the CableClip with
the top channel of the plastic holder.
Then insert one round end, press
down on the other round end and
slide CableClip into rail. Fig. 2
the top channel of the plastic holder.
Then insert one round end, press
down on the other round end and
slide CableClip into rail. Fig. 2
Note: Position CableClip about
halfway down each SuperSnap. Fig. 3
halfway down each SuperSnap. Fig. 3
Step 2
Push rod halfway into clip rail
of one SuperSnap. Fig. 4
of one SuperSnap. Fig. 4
Step 3
Insert rod into top clip rail of second
SuperSnap until both holders meet.
Fig. 5 & 6 Repeat steps 2-3 for
additional SuperSnaps.
SuperSnap until both holders meet.
Fig. 5 & 6 Repeat steps 2-3 for
additional SuperSnaps.
Instruction Sheet
Instructions for assembly
Incept-11.13.02
The SuperSnap™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSSuperSnapRodCCLoop
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSSuperSnapRodCCLoop
Figure 3
Figure 6
Figure 2
Figure 1
Figure 5
Figure 4
Page 1 of 2
SuperSnap
12S300
Cable Clip
06-5050
Loop & Saucer
16-0018SL
End Caps
06-5475
6” Rod
97-0304-06