Becker grand prix Operating Guide
105
User settings
User settings
Opening / quitting User
Settings menu
Settings menu
After requesting the user settings, the
following basic settings can be selected
according to your personal preferences.
following basic settings can be selected
according to your personal preferences.
•
Gal
- Speed-dependent volume
control (GAL)
•
Tel
- Telephone response
•
Lum
- Display brightness
•
Led
- Adjusting LED
•
M/S
- Adjusting reception
optimisation
•
Aux
- Adjusting the AUX input
•
BeV
- Adjusting signal tone volume
X
The user menu is requested by press-
ing the
ing the
button for longer than 2
seconds.
X
Press the
button again to quit
the user menu.
Setting the GAL (Gal)
The GAL is a car radio control circuit,
which automatically adjusts the car ra-
dio volume according to vehicle speed.
This results in compensation of the driv-
ing noise produced at higher speeds.
which automatically adjusts the car ra-
dio volume according to vehicle speed.
This results in compensation of the driv-
ing noise produced at higher speeds.
X
Calling up the user menu.
X
Press the
multifunction button.
X
With the right rotary control
, select
either
0
or
+15
.
The GAL setting can be used to specify
the starting point for the volume increase
according to vehicle speed.
The setting is stored automatically.
The settings are:
the starting point for the volume increase
according to vehicle speed.
The setting is stored automatically.
The settings are:
•
0
- No volume increase
•
+1
- Volume increase is initiated at
low speed
•
+15
- Volume increase is initiated at
higher speed
Telephone mute function (Tel)
If a telephone with hands-free operation
is installed, the call may be routed
through the speaker system. This elimi-
nates the need for an additional speaker.
However, the signal leads (AF – Tele-
phone input and Earth – Telephone in-
put) must be connected to the car radio
(see also page 121).
is installed, the call may be routed
through the speaker system. This elimi-
nates the need for an additional speaker.
However, the signal leads (AF – Tele-
phone input and Earth – Telephone in-
put) must be connected to the car radio
(see also page 121).
X
To set, call up user menu.
X
By pressing multifunction button
, select
Audio Sig.
or
Mute
.
•
Mute
- Telephone Mute setting
•
Audio Sig.
- Telephone conversa-
tion via car radio