MINOURA pair stand User Manual

!

O

X

(fig. J)

4

Place the Connecting Plates at the top of the Lower Pil-

lar. Connect the Upper Pillar to the Lower Pillar then

tighten the M6x14 bolts firmly.  Now the base frame is

completed.

5

(Fig. D)

(Fig. E)

6

(Fig. H)

For parts or service outside of Japan or North America, please con-

sult your local shop or refer our international distributor list (found

on our web site) for the distributor in your country.

1197-1 Godo, Anpachi, Gifu 503-2305 Japan

Phone: +81-(0)584-27-3131 / Fax: +81-(0)584-27-7505

Email: minoura@minoura.jp / Web: http://www.minoura.jp

(for North American residents only)

1996 East Avenue, Hayward, CA 94541-5454 U.S.A.

Fax: 1-510-538-5899 / Email: MinouraUSA@ATTglobal.net

MADE IN JAPAN

Copyright 2002 Minoura Co.,Ltd. All rights reserved

Assemble the cradles.

Place the Angle Adjust Plate onto the Lower Support,

then put the Alloy Stay on it.  Fix three parts with the

supplied M6x20 bolt in the upper hole. (see Fig. E)

Screw the supplied M6x15 bolt in the lower hole, but

you don’t need to tighten it so firmly at this time.

Next, you'll install the bike cradles to both the upper and

lower pillars.

Disassemble the band clip first. (see Fig. H)

Wrap the stainless band around the pillar, in-sert the end

of the band between another end and the rectangle nut.

Put the plastic bracket onto the band, attach the hook or

support arm, then tighten the bolt.

The distance between the plastic frame hooks can be

adjusted to fit different sized bikes.

To do so, loosen the rear nut and adjust the position of

the hook. After adjusted to the required position firmly

re-tighten the nut.

(see Fig. F)

7

(Fig. F)

The stainless band must ONLY be used on the

upper side of the cradle. Do NOT use it on the

bottom position of the cradle. (see Fig. G)

(Fig. G)

8

The cradle is adjustable in degrees.  If you want to move

the cradle, loosend the lower

bolt on the angle adjust plate,

change the

angle until the

displayed bike

will be

horizontally

as much as

possible then

tighten the bolt again. (see Fig. I)

(Fig. I)

To put a bike on PAIR STAND, lift the bike and gently place

the top tube into the frame hooks.

If the bike does not have a standard frame design, it should

be supported by the top tube and rear seatstay configuration.

(see Fig. J)

9

The inside nut of the stainless band clamp is not square, it is rectanle.

You have to remove the stainless band to wind up it around the pole

for assembling.  At this time, do NOT remove the nut from the band.

If you had removed the nut, make sure the nut direction that the

longer side must be vertical.  If you see there is some space between

the nut and stainless band, the direction is wrong.