husky-liners 6366 User Manual

6366 Front_Back.doc

10/30/03

CARE AND USE INSTRUCTIONS

     Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

     Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409

®

 or Glass Plus

®

 work well. Use of

Armor All

®

, Son-of-a-Gun

®

 or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150

SUPER CREW TRUCK SECOND SEAT FLOOR LINER

ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM
AWAY A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE
FRONT EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR
TRIMMING. USE OFFSET “STEP” AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS.
ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER’S SIDE REAR SEAT), TRIM
LINER AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE
BACK EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART
AS A GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE.

RIGHT OR

PASSENGER’S

SIDE

LEFT OR

DRIVER’S

SIDE

AREA 1

AREA 2