dhi installation and use of 32mm molbloc cradle kit pn 402134 User Manual

 

molbloc, molbloc-S, molbox, molstic and molstic-s are trademarks, registered and otherwise, of DH Instruments, Inc. 

VCR is a registered trademark of the Swagelok Company.

 

Document 560070 

040907 

4765 East Beautiful Lane 

Phoenix  AZ  85044-5318 

USA 

 

Tel 602.431.9100

Fax 602.431.9559

dhi@dhinstruments.com

www.dhinstruments.com

 

  With the molstic-S resting on its side, position the upstream cradle for the 32 mm molbloc-L into the desired 

location, either 1, 2, or 3. 

  Place a lock washer and then a flat washer onto the socket head cap screw. 

 

Thread the screw into the upstream cradle from the bottom side of the molstic platform and leave loose enough 
to allow for later adjustment. 

 

Thread another screw with lock washer and flat washer into the other side of the upstream cradle. 

 

Position the downstream cradle for the 32 mm molbloc-L into the desired location, either 4, 5, or 6. 

 

Thread screws into this cradle. 

 

Repeat these step with any other cradles that might need to be installed. 

 

For best alignment results, plumb the appropriate molbloc element into each branch of the molstic prior to final 
tightening of the socket head cap screws. 

The following parts are included in the shipment: 

Cradle, Low/Mid 

2

122440

SHC screw, M4 x 10 

4 

101015-Z 

Split lock washer, M4 

4 

102668-Z 

Flat washer, M4 

4 

100918-Z 

Instruction Sheet 

1 

560070