Manualsbrain.com
  1. Manuals
  2. Brands
  3. Carvin
  4. dcm1001
  5. User Manual

Carvin dcm1001 User Manual

Download
Page of 6
SHIELD
+POS.
2
1
3
-NEG.
SHIELD
+POS.
2
1
3
-NEG.
SHIELD (GROUND)
+ SIGNAL (BAL.)
- SIGNAL (BAL.)
BALANCED MIC/LINE
(Shielded)
2
3
BRIDGE switch 
must be OFF (OUT).
or
From Mixer Monitor 1 Output
Up to four monitors per side using 8 ohm systems
or two monitors per side with 4 ohm systems.
For dual monitor mix (stereo), the PARALLEL 
switch must be in the OUT position (OFF).
From Mixer Monitor 2 Output
TYPICAL DUAL MONITOR MIX SETUP
1
Twist-Lok
Twist-Lok
Housing
Contact
Insert
Cable
Clamp
Securing
Hub
• Connection Configuration: 
Black  (1+) / pos. full range mode, Low pos. Bi amp mode
White  (1-) /  neg. full range mode, Low neg. Bi amp mode
Red     (2+) / not used
Green  (2-) / not used
• Solder wires in contacts or use hex screws provided.
• Slip "Securing Hub" then "Cable Clamp" over cable before attaching wires.
1+
1-
2+
2-
Solder tinned wires 1/4"
Strip cable insulation back 3/4"
PARALLEL switch OFF (OUT).
To signal socket XLR or 1/4" 2 or 3 cond. shielded
Activate the BRIDGE switch 
(IN).  Control the level by Ch 1 
 (Ch 2 does not function.)
Ch 1 Input
Single speaker or
system connected
in BRIDGE mode.
Minimum imp. 4
Ω
Use either the 
Bridged Twist-Lok 
connector or the 
binding posts.  No 
other connections 
can be used while in 
Bridged mode. 
Mains
Monitors
Mains
Ch 1 Main Mix
Ch 2 Monitor Mix
BRIDGE switch 
must be OFF (OUT).
The PARALLEL switch 
must be OFF (OUT).
Right Full Range
For (stereo) the PARALLEL
switch must be OFF (OUT).
Left Full Range
Ch 1 Left
Ch 2 Right
BRIDGE switch 
must be OFF (OUT).
TYPICAL STEREO SETUP* 
(OR MONO BI-AMP)
MONO MAINS & MONITORS
BRIDGE MONO
25V or 70V 
Distribution System:
Wattage of transformer (TAP)
divided by total wattage
of Amp = Number of 
transformer/speaker(s)
that can be hooked up.
+
16
8
4
C
15w
7w
3w
1w
C
+
16
8
4
C
15w
7w
3w
1w
C
25V OR 70V DISTRIBUTION SYSTEM