Becker 7949 traffic provoice Operating Guide
54
Navigation mode
•
&DU
This is the default setting. It offers
sufficiently accurate calculation of the
ETA for most drivers.
sufficiently accurate calculation of the
ETA for most drivers.
•
9DQ
This setting indicates to the Traffic Pro
that you will need a little longer for the
planned route. This setting could be
selected, for example, for a slower
vehicle or in dense traffic areas.
that you will need a little longer for the
planned route. This setting could be
selected, for example, for a slower
vehicle or in dense traffic areas.
•
6HWIUHHO\
Select this option to modify the calcu-
lation of the ETA to suit your require-
ments.
lation of the ETA to suit your require-
ments.
X
Turn the rotary control/push button
to activate the required setting (
to activate the required setting (
).
If
6HWIUHHO\
is selected, you still need to
select the required setting. The available
range is between 50% and 200%.
A value of 100% indicates the
range is between 50% and 200%.
A value of 100% indicates the
&DU
set-
ting. A later ETA will be calculated if a
higher percentage value is selected.
higher percentage value is selected.
X
Turn the rotary control/push button
to set the required percentage value.
to set the required percentage value.
X
Confirm your selection by pressing
the rotary control/push button
the rotary control/push button
.
Measuring unit
You can convert the calculation of the
distances from metric (display in metres
and kilometres) to imperial (display in
yards and miles) system and vice versa.
distances from metric (display in metres
and kilometres) to imperial (display in
yards and miles) system and vice versa.
X
In the Settings menu, select the
8QLWRI
PHDVXUH
entry.
X
Confirm your selection by pressing
the rotary control/push button
the rotary control/push button
.
X
Select
0HWULF
or
,PSHULDO
(on =
).
Note:
Only one of the two settings may be
active (
active (
) at the same time.
2093
Note:
Only one of the two settings may be
active (
active (
).
2094
2095